Denture Cement at a Test

A UK manufacturer of denture cement / denture adhesive uses the LR Plus test machiene to test new formulations and control the quality of products in the manufacturing process.
Denture cement at a test
Denture cement, also known as denture adhesive, is used for a wide variety of dental work such as attaching braces to teeth and fitting temporary crowns.

This case story describes how a manufacturer of denture cement uses the LRPlus materials testing machine to test new formulations and control the quality of products in the manufacturing process.

Challenge
The performance of denture cement is affected by many parameters such as the condition and amount of saliva in the mouth, mouth temperature, the force applied by the jaw and the speed at which the jaw moves. Controlling these and isolating single parameters in the laboratory environment can be very difficult.

To achieve accurate test results using high precision testing machines, the manufacturer of denture cement looked to Lloyd Instruments to come up with a solution.

Solution
To single out each parameter that needed to be tested at the right force and under the right conditions, the denture cement supplier used the LRPlus test machine from Lloyd Instruments.

The LRPlus was fitted with a water bath on the lower anchor pin. Using a water bath allowed the denture cement supplier to vary the temperature of the bath to simulate different temperatures in the mounth.

Two aluminium plates were fitted to the machine. Denture adhesive was applied to the lower plate and fixed in the water bath.

The flexibility of the NEXYGENPlus materials testing software that was supplied with the LRPlus, allowed the upper plate to be brought into contact with the lower plate at an infinitely variable speed between 0.1 and 1020mm/min. The contact force could be varied up to 5000N.

The upper plate was then be pulled away from the lower plate to measure the adhesive force.

To simulate jaw opening and closing this procedure could be repeated an infinite number of times. A thermocouple fitted in the water bath feeded back the bath
temperature to NEXYGENPlus which logged the value with the test results for added traceability.

Test result showing seven consecutive pull off force measurements from the same sample:

Test result for denture cement testing

Download this case story as PDF